Chapter 192: A new Trial a new test. (2/2)

Luckily he was not a regular craftsman, he i so like a shock-resistant lamp would be quite easy First, he would need to find the correct components, no lio with anything

This did seem like a trial test, the instructions were minor and he had a lot of time Probably after he fashi+oned this runic lamp he would be shohat this trial was truly about For now, he was unsure if it would bemore to it

‘First, let me find a power source…’

While he would like to have used his own battery design he was unsure if that would be possible He was only able to charge the up his entire workshop It was a long process of development but luckily for him, he did find mana crystals that would do nicely

They were in an aisle filled with other ge shapes and sizes were also there but they all capped out at tier 2 The largest one that he could see was somewhat similar to the tier 2 boss monster dinosaur that he had defeated previously

Thanks to an old experience he knew that using a power source along with a weak runic enchant like a runic lalow similar to a desk lamp wouldn’t need that much mana to work Luckily mana fluid was also here and he had already seen soether with

Thus Roland began asseht theht that he had a lot of ti that he needed The whole place was quite new to hi that he wanted

First ca to be inserted into a small metal cylinder The fluid came in a canister that reminded him of ones used for fuel in his old world He had found a small funnel to help him pour it into the cylinder that first needed to have a hole punctured into it

“The tools here are outdated…”

He had hoped that this trial would somehow produce his runic power tools but there weren’t any It would have been easy if he had his runic drill along with his heating wands It would have been easy to just get the fluid in and then weld it shut Afterward, he could inscribe runes over it to , he would have to revert to his old blacks techniques What would be the battery was hollow on the inside so he only needed to puncture a hole through it after heating it up

The mana fluid was so via , it wouldn’t blow up into his face It just needed the proper runes on the outside to prevent it fro power from it

With the battery in place he now only needed to concentrate on the outer shell The only requireive out some heat and be resistant to minor shocks

This could be achieved in various ways but he was li The test didn’t mention that the item that he made required to be artistic in nature For that reason, he decided toits outside appearance

Thus the soh outer shell was made It was fashi+oned out of deep steel plates that he was very faether, to the botto so it set The required runes on the battery were already set in place before he attached it

In the end, the whole thing ended up looking like a box On the outside, there were visible runes that were engraved on the shi+ny grayish deepsteel After years of runecrafting it was quite easy for Roland to plan out the entire runic structure without any need for a proper sche just clicked into place and after injecting ht of exactly 450 luo for the et so the sweet spot

With a lack of instructions, he decided to ht in all directions equally Thus it could be placed on any side and it would continue glowing The whole procedure didn’t take hi Probably if he was more familiar with the layout and had his own tools he would have done it faster

The lass case In his hand, he had the sohtbox On one of the sides, there was a sh which he would be able to turn it on The test didn’tabout on and off switches

‘I hope this is enough…’

After turning it on he placed it into the glass case He still had some time that he could spend on some improvements but he felt like speed also counted into the test Perhaps he would be given more time for the next creation if he turned this one in faster

The round go out At first, he expected it to just vanish but instead, the whole glass case started sliding down into the ground

It was similar to the previous trial he took where the workshop slid down into the battleground to make way for the battle Here it was a bit different as soon as the container with his iteain There was a difference though, the square box that he placed inside was no more

“So what now?”

He looked at the elowing had stopped and noas just waiting It took a fewdown had also stopped which

Soon the monitor that was below the timer suddenly went on At first, it looked like static, it was as if there was no signal but with ti on the screen It looked like a huure, it started out soe became sharp

“A mannequin?”

What he saas not a human, it was some kind of puppet It had all the required joints that a person would find on a du in any shapes and was devoid of eyes, a nose, and ain a chair while leaning forward

Then Roland noticed it, the box that he made was placed on some other books that were on a desk This desk was the one that this puppet was sitting in, itto read another book while using his box as the source of light

“What is this…”

At first, Roland was not sure what to ames that he played when he was still in the old world There were sos to the world and then watched a sie from provided parts and then see if the sie collapsing onto itself

This looked so to siht requirement was for this part and soon he would knohy it also needed to be shock resistant Thearound and it elbowed the stack of books that the lightbox was on

The box fell down to the ground along with soe froh this fall The puppet slowly leaned back down to pick up the box as it went back to reading Froht, it was as if it was trying to waruess that’s why it wanted it to give out a wareness of this trial It seemed that he would need to predict the simulated scenario that would take place on this TV screen Along with following the instructions that were probably events happening during the sie turned back to the static

Before he could deliberate if he did well or not the screen shi+fted to another ie This time around he could see a table ords in it The moment he read the first one he already knehat it was