Chapter 138: Insignia (1/2)
The training continued. In a large classroom, all the AK47s were in front of the desk, finally. I stood in front of them and spoke up.
“Today we are going to disassemble and clean the AK47. First, as instructed, let’s remove the pieces in order.”
Even if the other party is Layara, she could do disassembly work for the AK47… right? While worried in my chest, I disassemble my AK47 placed on the desk in order.
“First of all, there is a protrusion on the part of the trigger guard in front of the pulling iron trigger. When removing the magazine, push the protrusion and pull out the magazine.”
After removing the magazine and showing it to everyone, I moved on to the next step
.
“Change the selector lever in a safe position to a different position —that is, fully automatic or semi-auto position. At that time, check the remaining bullets of the chamber. Be careful because it is extremely dangerous if there are bullets left.”
The girls move their hands according to my words and movements.
“Pull the cocking handle, the hammer, and then remove the cleaning rod attached to the barrel. The cleaning rod is independent and can be removed before removing the magazine, since it is better to always keep the same disassembly procedure, we will remove it at this point in the future. Then press the lock at the rear of the bolt carrier and remove it back to pull up the bolt carrier cover.”
The cleaning rod is a thin rod-like part that lies parallel to the bottom of the barrel when viewed from the side. As the name implies, it is used for cleaning guns.
There were a few girls who took a little time and effort to work here. I waited until they could safely remove the bolt carrier cover. After confirming the removal, I proceeded to the next step.
“After removing the cover, push the back of the guide retaining block connected to the recoil spring and remove it from the receiver. And pull the Bolt Carrier Group, which, as the name suggests, moves the bolt, to the back of the receiver, lift it up and remove it.”
The “bolt carrier group”, which can be finally removed by removing the cover and removing the recoil spring, is the part located at the very center of the gun, including the bolt (bottom) that hits the bullet.
We placed the removed parts of the “Bolt Carrier Group” on the desk.
“Next, I’m going to get on the handguard. The handguard, which protects the hand from heat generated from the barrel. The barrel is divided into two parts: the top and the bottom. The top of the handguard can be removed by lifting the gas cylinder up and removing the takedown latch. In addition, pull the bottom of the handguard down and pull it forward.”
The parts were lined up on the desk one after another. Then we proceeded to remove the last part.
“Finally, remove the bolt from the bolt carrier and the disassembly is over.”
It can be disassembled into 8 parts except for the main body on the desk. The AK series are sturdy because it is so easy to make.
Even the AK, which is tough and strong against dirt, needs cleaning. Therefore, they must learn how to disassemble.
This time, I reassembled it, and I allowed it to be disassembled by one person because it’s okay to do it slowly.
▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼
The training continues.
They all had a helmet, a combat protector, Alice clip, a spare magazine, and an AK47 to train rushing lashing.
This was the most used technique in movement techniques.