Part 5 (1/2)
A prominent feature in the appearance of the Siemens burner, as will be seen from the annexed ill.u.s.tration, is a large metal chimney, for creating a draught to carry away the products of combustion. The entrance to this chimney is situated a little above the apex of the flame; but there is a branch flue connecting the main chimney with the interior of the burner. The body of the burner is of metal, and its interior is divided into three concentric chambers. Of these, the innermost is open at the top, and is surmounted by a porcelain cylinder, which, when the gas is lighted, is surrounded by the flame.
This chamber is closed at the bottom, but communicates at the side with the before-mentioned branch tube, or flue, leading to the main chimney. The intermediate chamber communicates, at its lower extremity, with the gas supply; and terminates, a short distance from the top of the burner, in a number of small metal tubes, which convey the gas to the point of ignition. The outer chamber is open both at top and bottom, and is for conveying air to support the combustion of the gas. In order to promote greater intensity of combustion, there is a notched deflector at the summit of the latter chamber, and another on the lower part of the porcelain cylinder, which cause the air to impinge more directly upon both sides of the flame. There is also an arrangement for introducing air between the outer casing of the air chamber and the gla.s.s chimney which encloses the flame; its object being to keep the chimney cool.
[Ill.u.s.tration: ELEVATION.
ENLARGED SECTION OF COMBUSTION CHAMBERS.
FIG. 20.--SIEMENS'S REGENERATIVE GAS-BURNER.]
[Sidenote: Action of the Siemens burner.]
The action of the burner is as follows:--When the gas is ignited at the ring of tubes, the heated air and products of combustion, which rise from the flame, create a draught in the main chimney. Through the communication established by means of the lateral flue, a partial vacuum, or area of low pressure, is induced in the innermost chamber of the burner, and within the porcelain cylinder which surmounts it.
As the flame terminates close to the mouth of the latter, the greater portion of the products of combustion, instead of going into the main chimney, are sucked into the porcelain cylinder; and thus a current is set up through the interior of the burner, and by the lateral flue, to the main chimney. The heat carried away by the products of combustion is communicated, through the walls of the chambers, to the entering gas and air; and by this means the latter are heated to a very high temperature before they issue from the burner and are consumed. The consequence is that a much greater intensity of combustion is maintained; the carbon particles are separated earlier in the flame, and are raised to a more exalted temperature; and the ultimate effect is a higher yield in illuminating power per cubic foot of gas consumed. Independent tests by various experienced photometrists have conclusively shown that a light equivalent to that from 5 to 6 candles is obtained per cubic foot, from gas which, in the standard ”London”
Argand, yields a light of only from 3 to 3-1/2 candles.
[Sidenote: Defects of the Siemens burner.]
While the advantages of the Siemens burner are many and obvious, it is not without its disadvantages. These partly arise from causes connected with the very observance of the conditions necessary to secure the efficiency of the burner. With every advance in the more efficient operation of gas-burners, increased care and attention are demanded in their employment, in order to obtain the benefits they are calculated to yield. Indeed, it would almost appear that the nearer the approach to perfection which is made in the construction of a burner, the greater must be the drawbacks to its general adoption.
Thus, in the burner under notice, if the gas supply is allowed to become in excess, the tail of the flame enters the porcelain cylinder, and soot is deposited in the interior of the burner; obstructing the pa.s.sages, and impairing the burner's action. Then, to cause the burner to yield its highest results, it is necessary that the air supply be accurately adjusted to the quant.i.ty of gas being consumed. To this end the entrance to the air chamber, at the bottom of the burner, is covered by a perforated semi-circular cup, by turning which the quant.i.ty of air entering the burner can be increased or diminished as required. Moreover, the bulky construction of the burner, with its accompaniment of chimney and flue, and its complicated arrangement of tubes and chambers, imparts to it a somewhat clumsy and inelegant appearance, which is calculated to impair the favour with which its remarkable performances cause it to be regarded. But these drawbacks are far outweighed by the undoubted advantages conferred by the burner--in improved illumination combined with economy of combustion, and the facilities it affords for securing perfect ventilation.
Encouraged by the success of Herr Siemens, other inventors have followed in his footsteps; with the result that there are now a variety of burners before the public, embodying the same principles, but differing in the details of their construction and in the measure of their efficiency. Of these may be mentioned Grimston's, Thorp's, and Clark's; and without describing in detail the construction of the several burners (of which further particulars will be found in the ”Register of Patents” in the _Journal of Gas Lighting_[14]), it must suffice to refer to the salient points and distinctive features of each.
[14] See Vol. XL., pp. 786, 950; and Vol. XLII, p. 836.
[Sidenote: Grimston's regenerative burner.]
Grimston's burner (shown on the next page) consists, in effect, of an Argand burner turned upside down; the gas issuing from the bottom ends of a number of small tubes placed in a circle. The jets of flame--first directed downwards from the mouths of these tubes--by a conoidal deflector in the centre of the ring, are caused to spread outwards, and a.s.sume a horizontal direction; and by their amalgamation with each other a continuous sheet or ring of flame is produced. The horizontal direction of the flame is maintained by its pa.s.sing underneath a metal f.l.a.n.g.e, faced with white porcelain, or other refractory material; the supply of gas being adjusted so that the flame just terminates at the outer edge of this f.l.a.n.g.e. Before entering the chimney, the products of combustion are caused to flow through a number of vertical tubes contained in a cylinder, which is concentric to an inner cylinder containing the gas-supply tubes. The outer cylinder is traversed by the air needed for the support of combustion, which is to become heated before reaching the point of ignition; and in order the more completely to enable the products of combustion to impart their heat to the entering air, the cylinder is further intersected by strips of wire gauze, which pa.s.s around and between the tubes (see fig. 22, on next page). By these means the air is intensely heated; and, pa.s.sing among the narrow burner tubes through which the gas is conveyed, gives up a portion of its heat to the latter before the point of ignition is reached. Thus, in a very simple manner, both air and gas are raised to a considerable temperature before combustion takes place.
With regard to the efficiency of the burner, at the exhibition of gas appliances held at Stockport in 1882 (where a gold medal was awarded to it, as well as to Thorp's burner, to be referred to hereafter), with a consumption per hour of 984 cubic feet of 175 candle gas, an illuminating power of 6067 candles was obtained (equal to 616 candles per cubic foot); while, on another occasion, when the burner was consuming 894 cubic feet per hour, an illuminating power of 515 candles (equal to 576 candles per cubic foot) was obtained from gas of the same quality. It is claimed for this burner that equally good results are obtained with small sizes as with large; and this, if borne out in actual practice, should go far towards ensuring the success and extensive adoption of the burner.
[Ill.u.s.tration: FIG. 21.--GRIMSTON'S REGENERATIVE GAS-BURNER.]
[Ill.u.s.tration: FIG. 22.--GRIMSTON'S BURNER.
PLAN, SHOWING REGENERATING ARRANGEMENT.]
[Ill.u.s.tration: FIG. 23.--THORP'S REGENERATIVE GAS-BURNER.]
[Sidenote: Thorp's regenerative burner.]
Thorp's burner produces a cylindrical flame, like that of the Argand, but without the aid of a gla.s.s chimney which is a necessary adjunct to the latter burner. By means of a deflector on the inner side of the flame, the latter is made to curve outwards and a.s.sume a somewhat convex form, so as to obviate the shadow which otherwise would be cast by the gas chamber at the bottom of the burner. Above the flame is a cylindrical chimney, divided by a vertical part.i.tion into two concentric chambers, which are intersected by a series of metal gills, or projections, continued through both chambers. The outer chamber is for conveying away the products of combustion; the inner one for the pa.s.sage of air to feed the flame; while down the centre of the inner chamber there pa.s.ses a tube conveying the gas to the point of ignition. The hot products of combustion pa.s.s up from the flame through the outer chamber, and give up the greater portion of their heat to the projections; by which it is conducted into the inner chamber, and transferred to the incoming air. A common imperfection of regenerative burners is that, in consequence of the diminished rate at which the gas flows through the burner when expanded by heat, when starting the burner the gas must be only partially turned on, and the quant.i.ty gradually increased as the burner becomes heated; thus necessitating considerable attention. To prevent the need for this attention, there is in Thorp's burner an ingenious contrivance for automatically regulating the quant.i.ty of gas admitted to the flame.
The central gas-tube, which is referred to above, contains a bra.s.s rod, fixed at one end, and at the other connected to a valve controlling the quant.i.ty of gas that enters the tube. At first, when the gas is lighted, this valve is almost closed; but as the rod becomes heated it elongates, gradually opening the valve until the full quant.i.ty of gas is admitted which the burner is intended to consume. At the Stockport exhibition, Thorp's burner was tested with the following results, as recorded in the Judges' report. After it had burned about two hours, ”it gave an illuminating power of 183 standard candles, while burning 27 cubic feet of gas per hour (equal to 677 standard candles per cubic foot), with gas of 35 candles per cubic foot.... In another experiment with the same quality of gas, after burning half an hour it yielded, under similar conditions, 154 candles with a consumption of 2529 cubic feet per hour, which gave an illuminating power of 602 candles per cubic foot.”
[Sidenote: Clark's regenerative burner.]
There is nothing in Clark's burner that calls for special notice. In its main features it appears to be constructed upon similar lines to Grimston's burner, although the coincidence is doubtless only accidental.[15] It must, however, be added that in the details of its construction it is much simpler than the latter burner; and certainly it appears to lose very little in efficiency from its greater simplicity, as the following extract from a report by Mr. F. W.
Hartley, the well-known photometrist, will show:--”With a consumption rate of 53 cubic feet of gas per hour, the amount of light yielded horizontally was equal to 2979 times that of a standard candle. The light yielded per cubic foot of gas burned per hour was therefore equal to 562 times that of a standard candle.” And the amount of light delivered immediately downwards is said to be ”very sensibly greater than the amount of light delivered horizontally.” Like the Grimston burner, it is of the inverted Argand form; the gas issuing from a chamber at the bottom of a tube which descends through the centre of the burner. The products of combustion escape through a chimney; and in so doing give up a portion of their heat to the entering air, which is conveyed to the point of ignition through horizontal tubes that intersect the chimney. The burner is enclosed in a suitable lantern, the lower half of which consists of a semi-globular gla.s.s; a similar arrangement being adopted in connection with the Grimston and Thorp burners.
[15] In justice to Mr. Clark it should be mentioned that, since the above appeared in the _Journal of Gas Lighting_, the attention of the writer has been called to the fact (which had been overlooked by him) that Clark's patent was taken out some months before that of either Grimston or Thorp.