Part 14 (2/2)

The sole object of the propeller is to translate the power of the engine into thrust.

The propeller screws through the air, and its blades, being set at an angle inclined to the direction of motion, secure a reaction, as in the case of the aeroplane's lifting surface.

This reaction may be conveniently divided into two component parts or values, namely, Thrust and Drift (see ill.u.s.tration overleaf).

The Thrust is opposed to the Drift of the aeroplane, and must be equal and opposite to it at flying speed. If it falls off in power, then the flying speed must decrease to a velocity, at which the aeroplane drift equals the decreased thrust. The Drift of the propeller may be conveniently divided into the following component values:

_Active Drift_, produced by the useful thrusting part of the propeller.

_Pa.s.sive Drift_, produced by all the rest of the propeller, _i.e._, by its detrimental surface.

_Skin-Friction_, produced by the friction of the air with roughness of surface.

_Eddies_ attending the movement of the air caused by the action of the propeller.

_Cavitation_ (very marked at excessive speed of revolution). A tendency of the propeller to produce a cavity or semi-vacuum in which it revolves, the thrust decreasing with increase of speed and cavitation.

THRUST-DRIFT RATIO.--The proportion of thrust to drift is of paramount importance, for it expresses the efficiency of the propeller. It is affected by the following factors:

_Speed of Revolution._--The greater the speed, the greater the proportion of drift to thrust. This is due to the increase with speed of the pa.s.sive drift, which carries with it no increase in thrust. For this reason propellers are often geared down to revolve at a lower speed than that of the engine.

_Angle of Incidence._--The same reasons as in the case of the aeroplane surface.

_Aspect Ratio._--Ditto.

_Camber._--Ditto.

[Ill.u.s.tration: M, Direction of motion of propeller (rotary).

R, Direction of reaction.

T, Direction of thrust.

AD, Direction of the resistance of the air to the pa.s.sage of the aeroplane, _i.e._, aeroplane drift.

D, Direction of propeller drift (rotary).

P, Engine power, opposed to propeller drift and transmitted to the propeller through the propeller shaft.]

In addition to the above factors there are, when it comes to actually designing a propeller, mechanical difficulties to consider. For instance, the blades must be of a certain strength and consequent thickness. That, in itself, limits the aspect ratio, for it will necessitate a chord long enough in proportion to the thickness to make a good camber possible. Again, the diameter of the propeller must be limited, having regard to the fact that greater diameters than those used to-day would not only result in excessive weight of construction, but would also necessitate a very high undercarriage to keep the propeller off the ground, and such undercarriage would not only produce excessive drift, but would also tend to make the aeroplane stand on its nose when alighting. The latter difficulty cannot be overcome by mounting the propeller higher, as the centre of its thrust must be approximately coincident with the centre of aeroplane drift.

MAINTENANCE OF EFFICIENCY.

The following conditions must be observed:

1. PITCH ANGLE.--The angle, at any given point on the propeller, at which the blade is set is known as the pitch angle, and it must be correct to half a degree if reasonable efficiency is to be maintained.

<script>